|
How the Cubby Vac
Central Home Cleaning Center Works
The hose handle, which is stored in the
upper compartment, has lite-touch buttons. The first two buttons
control the hose management system which extends and retracts the
hose. The next two buttons control the vac motor and the electric
power nozzle. With a touch of the (out) button, the hose
management system extends the hose to the length required.
Next, hook up the floor tools and start vacuuming. When
you're finished just touch the (in) button and the system will retract
the hose for easy and sightless storage.
Preparation & Installation
The Cubby Vac Central Home Cleaning
Center is designed to be installed recessed in a clear wall stud cavity
in a new or existing home. Select a stud cavity in a central
location in the home, cut an opening starting 1" above the
baseboard, 14½" wide and 71½" high. Then set the Cubby
Vac unit in the opening and install 2 thumb screws in either side and
plug it into an adjacent 120 volt grounded wall outlet. For new
construction, have electrician run a dedicated 20 amp line to the stud
cavity. The unit protrudes only 1/8 2⅛"
at the top and 3¼" at the bottom making a slim line fit. The
Cubby Vac Central Home Cleaning Center can also be installed flush
through a closet door or surface mounted on the inside of the
door. Installation time is approximately 30 to 45 minutes.
See
Installation Picture
Home size:
The Cubby Vac's reach of 45' and 55',
centrally located and depending on floor plan, will service up to a 2500
square foot home from one location. Two story homes often require
one unit on each floor.
See
Floor Plan
Decor:
To match the decor in a new or existing
home, decorator doors or mirrors may be added to the existing doors to
blend and enhance the unit.
|